boaz2020
Cadet
- Joined
- Jun 28, 2012
- Messages
- 8
I had a FreeNAS 0.7x release installed and had two zpool's under that setup working fine, they were tank0 and tank1.
I have installed FreeNAS 8.0.4-RELEASE-p3 onto a 2GB USB stick, replacing the older installation.
Booted FreeNAS 8.0.4p3 no problems.
I used the auto import facility in the GUI (it showed both pools tank0, and tank1) to import tank0, no problems.
I tried to use the auto import facility again for tank1, only this time, no zpools were shown in the import dialog.
Hopped over to the CLI and ran: zpool import; this command correctly identified the second zpool (tank1) available for import.
Ran: zpool import tank1; no problems.
The GUI however can't see the secondary zpool I just imported.
The output from zpool status is as follows:
Does anyone have an idea as to what I'm doing wrong?
I have installed FreeNAS 8.0.4-RELEASE-p3 onto a 2GB USB stick, replacing the older installation.
Booted FreeNAS 8.0.4p3 no problems.
I used the auto import facility in the GUI (it showed both pools tank0, and tank1) to import tank0, no problems.
I tried to use the auto import facility again for tank1, only this time, no zpools were shown in the import dialog.
Hopped over to the CLI and ran: zpool import; this command correctly identified the second zpool (tank1) available for import.
Ran: zpool import tank1; no problems.
The GUI however can't see the secondary zpool I just imported.
The output from zpool status is as follows:
Code:
[root@freenas] ~# zpool status pool: tank0 state: ONLINE status: The pool is formatted using an older on-disk format. The pool can still be used, but some features are unavailable. action: Upgrade the pool using 'zpool upgrade'. Once this is done, the pool will no longer be accessible on older software versions. scrub: none requested config: NAME STATE READ WRITE CKSUM tank0 ONLINE 0 0 0 raidz2 ONLINE 0 0 0 ada0p1 ONLINE 0 0 0 ada1p1 ONLINE 0 0 0 ada2p1 ONLINE 0 0 0 ada3p1 ONLINE 0 0 0 ada4p1 ONLINE 0 0 0 ada5p1 ONLINE 0 0 0 raidz2 ONLINE 0 0 0 ada1p2 ONLINE 0 0 0 ada3p2 ONLINE 0 0 0 ada4p2 ONLINE 0 0 0 ada5p2 ONLINE 0 0 0 errors: No known data errors pool: tank1 state: ONLINE status: The pool is formatted using an older on-disk format. The pool can still be used, but some features are unavailable. action: Upgrade the pool using 'zpool upgrade'. Once this is done, the pool will no longer be accessible on older software versions. scrub: none requested config: NAME STATE READ WRITE CKSUM tank1 ONLINE 0 0 0 raidz1 ONLINE 0 0 0 ada1p3 ONLINE 0 0 0 ada4p3 ONLINE 0 0 0 ada5p3 ONLINE 0 0 0 errors: No known data errors
Does anyone have an idea as to what I'm doing wrong?