Hi,
My FreeNAS system has run fine for about 200 days. I wanted to upgrade from 9.10 to 9.10.2u6.
I shutdown all the jails, turned off all services and proceeded to upgrade to 9.10.2u6. After rebooting I couldn't get one of my 3 volumes to unlock/import.
ada0 = SSD1 - Single SSD (jails)
ada1 = OS/Boot - Single SSD
da0-5 = Data1 - 6 disk WD Red RAIDZ2
ada2/3 = Data2 - 2 disk WD Red RAIDZ0
When I came to unlock each volume I found the following:
Data2 - Unlocked OK with passphrase.
Data1 - couldn't be found when attempting to unlock, so I detached it and re-imported as per the manual - unlocked OK with encryption key file + passphrase.
SSD1 - couldn't be found when attempting to unlock, so I did the same as above, but when following the 'Import Volume' wizard, it couldn't be found.
I booted to my original installation and restored my configuration with the same problem.
The disk is available to be set up as a new volume, or can be used with 'Import Disk' but obviously I'd prefer to recover the volume where possible.
It doesn't have any critical data on it, but it would save a few hours setting up the jails again.
Any help appreciated.
Thanks
My FreeNAS system has run fine for about 200 days. I wanted to upgrade from 9.10 to 9.10.2u6.
I shutdown all the jails, turned off all services and proceeded to upgrade to 9.10.2u6. After rebooting I couldn't get one of my 3 volumes to unlock/import.
ada0 = SSD1 - Single SSD (jails)
ada1 = OS/Boot - Single SSD
da0-5 = Data1 - 6 disk WD Red RAIDZ2
ada2/3 = Data2 - 2 disk WD Red RAIDZ0
When I came to unlock each volume I found the following:
Data2 - Unlocked OK with passphrase.
Data1 - couldn't be found when attempting to unlock, so I detached it and re-imported as per the manual - unlocked OK with encryption key file + passphrase.
SSD1 - couldn't be found when attempting to unlock, so I did the same as above, but when following the 'Import Volume' wizard, it couldn't be found.
I booted to my original installation and restored my configuration with the same problem.
The disk is available to be set up as a new volume, or can be used with 'Import Disk' but obviously I'd prefer to recover the volume where possible.
It doesn't have any critical data on it, but it would save a few hours setting up the jails again.
Any help appreciated.
Thanks
Last edited: