Hello,
I used this guide to begin the long backup process of my FreeNAS to Amazon's storage. Unfortunately (or maybe not?) I started the command
using SSH, specifically via Putty, on my home PC.
I used this guide to begin the long backup process of my FreeNAS to Amazon's storage. Unfortunately (or maybe not?) I started the command
Code:
s3cmd -v sync /mnt/ s3://MyBucket
using SSH, specifically via Putty, on my home PC.
- If I quit Putty, will backup continue? Or will it completely stop (as I noticed it would if using the GUI shell)? If it stops, and I start it again on my machine with the help of a monitor and keyboard, will it continue from where it left off or start completely over?
- As a side question, is there anyway I could automate this process? For example, to upload any new files to Amazon once a month?
- And finally, I'm assuming my data is not automatically encrypted by Amazon and that it will remain in its original unencrypted state if I haven't done so manually. If this is correct, will directing FreeNAS to encrypt the hard drives and then upload data to Amazon make FreeNAS encrypted versions of my data? Or is it only the physical hardware itself that is encrypted?
Last edited by a moderator: