Hello,
So I installed FreeNAS 9.1.0.1.573 on my computer, and was faced with a couple of problems.
When I tried to configure the network interfaces I had to chose between 3 interfaces, with some trial and error, I (think) I found the right one becuase it was the only one that let me have an IPother than 0.0.0.0
So thinking I was clear out of the woods, I entered the IP it spat at me after I configured the network IP address (192.168.1.107) it would take forever on chrome/ff/ie and then fail. So I tried to ping it from cmd instead, and I keep getting
I also tried pinging my own laptop from the NAS by openning the shell and typing (ping 192.168.1.103), and got
the way my network is setup is like this:
I hope my ascii drawing was explanatory enough.
Let me know if there's any other information that could assist you
So I installed FreeNAS 9.1.0.1.573 on my computer, and was faced with a couple of problems.
When I tried to configure the network interfaces I had to chose between 3 interfaces, with some trial and error, I (think) I found the right one becuase it was the only one that let me have an IPother than 0.0.0.0
So thinking I was clear out of the woods, I entered the IP it spat at me after I configured the network IP address (192.168.1.107) it would take forever on chrome/ff/ie and then fail. So I tried to ping it from cmd instead, and I keep getting
Request timed out.
I also tried pinging my own laptop from the NAS by openning the shell and typing (ping 192.168.1.103), and got
.Host is down
the way my network is setup is like this:
Code:
[BELL 2WIRE router/internet]------------(lan)-------------[basement Linksys router]-------(lan)--------[NAS computer] |_______otherComputers |_____(wan)_____[laptop]
I hope my ascii drawing was explanatory enough.
Let me know if there's any other information that could assist you