giuseppe30
Dabbler
- Joined
- Dec 20, 2020
- Messages
- 36
Hello,
I have TrueNAS-12.0-U3.1 machine with 3x HGST 8TB stripe pool and Dell perc h310.
today I have this critical message: ATA error count.
I have TrueNAS-12.0-U3.1 machine with 3x HGST 8TB stripe pool and Dell perc h310.
today I have this critical message: ATA error count.
Code:
Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: HGST Ultrastar HC310/320 Device Model: HGST HUS728T8TALE6L4 Serial Number: VGJT1PUK LU WWN Device Id: 5 000cca 0bee71e4f Firmware Version: V8GNW980 User Capacity: 8,001,563,222,016 bytes [8.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Mon Jun 14 21:51:29 2021 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 87) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 873) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 100 100 016 Pre-fail Always - 0 2 Throughput_Performance 0x0005 132 132 054 Pre-fail Offline - 96 3 Spin_Up_Time 0x0007 162 162 024 Pre-fail Always - 509 (Average 497) 4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 25 5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0 7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0 8 Seek_Time_Performance 0x0005 128 128 020 Pre-fail Offline - 18 9 Power_On_Hours 0x0012 100 100 000 Old_age Always - 1059 10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 25 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 67 193 Load_Cycle_Count 0x0012 100 100 000 Old_age Always - 67 194 Temperature_Celsius 0x0002 139 139 000 Old_age Always - 43 (Min/Max 23/57) 196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0 197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 13 SMART Error Log Version: 1 ATA Error Count: 13 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 13 occurred at disk power-on lifetime: 1056 hours (44 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 10 00 c8 cb a9 40 00 01:56:15.190 READ FPDMA QUEUED 60 10 00 88 c8 a9 40 00 01:56:15.146 READ FPDMA QUEUED 60 10 10 98 c8 a9 40 00 01:56:15.146 READ FPDMA QUEUED 60 10 08 78 c8 a9 40 00 01:56:15.146 READ FPDMA QUEUED 60 10 00 68 c8 a9 40 00 01:56:15.146 READ FPDMA QUEUED Error 12 occurred at disk power-on lifetime: 1056 hours (44 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 10 00 e0 01 92 40 00 01:52:00.145 READ FPDMA QUEUED 60 10 10 00 02 92 40 00 01:52:00.145 READ FPDMA QUEUED 60 10 08 f0 01 92 40 00 01:52:00.145 READ FPDMA QUEUED 60 10 00 d0 01 92 40 00 01:52:00.145 READ FPDMA QUEUED 60 10 00 c0 01 92 40 00 01:52:00.144 READ FPDMA QUEUED Error 11 occurred at disk power-on lifetime: 1056 hours (44 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 00 00 90 a2 9c 40 00 01:50:34.826 READ FPDMA QUEUED 60 10 08 70 81 1c 40 00 01:50:34.826 READ FPDMA QUEUED 60 10 10 80 a2 9c 40 00 01:50:34.826 READ FPDMA QUEUED 60 10 08 70 a2 9c 40 00 01:50:34.826 READ FPDMA QUEUED 60 20 00 50 a2 9c 40 00 01:50:34.826 READ FPDMA QUEUED Error 10 occurred at disk power-on lifetime: 1056 hours (44 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 10 10 60 9f 70 40 00 01:46:33.674 READ FPDMA QUEUED 60 10 00 80 9f 70 40 00 01:46:33.674 READ FPDMA QUEUED 60 10 08 50 9f 70 40 00 01:46:33.674 READ FPDMA QUEUED 60 10 00 70 9f 70 40 00 01:46:33.674 READ FPDMA QUEUED 60 10 08 40 9f 70 40 00 01:46:33.670 READ FPDMA QUEUED Error 9 occurred at disk power-on lifetime: 1056 hours (44 days + 0 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 00 00 00 00 00 Error: ICRC, ABRT at LBA = 0x00000000 = 0 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 10 00 b0 d4 0b 40 00 01:39:12.529 READ FPDMA QUEUED 60 10 08 c0 d4 0b 40 00 01:39:12.529 READ FPDMA QUEUED 60 10 08 a0 d4 0b 40 00 01:39:12.529 READ FPDMA QUEUED 60 10 00 90 d4 0b 40 00 01:39:12.529 READ FPDMA QUEUED 60 10 10 70 d4 0b 40 00 01:39:12.529 READ FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 1059 - # 2 Short offline Completed without error 00% 989 - # 3 Short offline Completed without error 00% 821 - # 4 Short offline Completed without error 00% 581 - # 5 Short offline Completed without error 00% 416 - # 6 Extended offline Completed without error 00% 358 - # 7 Short offline Completed without error 00% 248 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing