surrealillusion
Cadet
- Joined
- May 26, 2014
- Messages
- 8
I've come across an odd behaviour when replacing a disk in our zpool. Following the instructions in the docs on replacing a failed drive and having it re-silver a spool status shows all drives are online and the pool is healthy. The GUI on the other hand shows a few things that weren't there before.
Attached are two screenshots of the View Disks and Multipath tabs. Originally when the pool was set up none of the disks were listed in the GUI and disk1 was in the Multipath tab (assigned to da0 and da2, which now only shows disks 2-23).
Hardware specs:
CPU: 2 x Intel Xeon E5 2620
Motherboard: Supermicro X9DRI-LN4F
RAM: 128GB
HBA: LSI 9207-8e
NIC: Intel Quad port ET
IPMI: 172.17.16.24 (dedicated NIC port)
FreeNAS 9.2.1.6
Attached are two screenshots of the View Disks and Multipath tabs. Originally when the pool was set up none of the disks were listed in the GUI and disk1 was in the Multipath tab (assigned to da0 and da2, which now only shows disks 2-23).
Hardware specs:
CPU: 2 x Intel Xeon E5 2620
Motherboard: Supermicro X9DRI-LN4F
RAM: 128GB
HBA: LSI 9207-8e
NIC: Intel Quad port ET
IPMI: 172.17.16.24 (dedicated NIC port)
FreeNAS 9.2.1.6
Attachments
Last edited: