I have been running FreeNAS 9.3-STABLE for about 2 months now. Got everything configured under ESXi 6.0 using the VMXNET3 interfaces as VMX3F0 and VMX3F1. Also have a Plex jail manually setup using directions found on here instead of the plug-in.
Upgraded from the GUI to 9.10-STABLE and my interfaces went to VMX0 and VMX1 upon reboot. From the command prompt I was able to figure out how to get VMX0 assigned so I could use the Web GUI. However, I cannot figure out how to get my jail reattached properly so the network interface of the jails is correct. I have VIMAGE selected for the jails, and I know if I turn this off I can select the "new" VMX0. But I would prefer to keep all my settings as they were.
Any insight would be greatly appreciated.
Upgraded from the GUI to 9.10-STABLE and my interfaces went to VMX0 and VMX1 upon reboot. From the command prompt I was able to figure out how to get VMX0 assigned so I could use the Web GUI. However, I cannot figure out how to get my jail reattached properly so the network interface of the jails is correct. I have VIMAGE selected for the jails, and I know if I turn this off I can select the "new" VMX0. But I would prefer to keep all my settings as they were.
Any insight would be greatly appreciated.