Volume entry not shown after being created

[f64897011]

Hi there,

I'm using FreeNAS 9.2.1.5-release on a Supermicro chassis with 24 disks installed. When I used the "Manual Setup" wizard of WebGUI ZFS volume manager to create a 10 disks raidz2 * 2 volume it showed successfully created. But there's no volume entry on the GUI unless I refresh Chrome. Everything else is working fine (zpool status, etc). I've also tried "manual setup" of 9.2.1.4, 9.2.1.3, 9.2.1.2 they all failed to show the volume entry until I refresh the explorer. Anyone encountered the same problem or any help would be very appreciated. Hope this one can be fixed in the near 9.2.1.6 release.

 

[dlavigne]

Unless there's a bug report at trac.pcbsd.org, it won't get fixed at all. If you create one, post the issue number here.

 

[f64897011]

Unless there's a bug report at trac.pcbsd.org, it won't get fixed at all. If you create one, post the issue number here.

Thanks! The issue # is 1192 now.

 

[solarisguy]

I think it was meant to be https://bugs.freenas.org/

 

[f64897011]

I think it was meant to be https://bugs.freenas.org/

#5317 as it is now.