I tried to upgrade from 11U3 to 11U4 and it borked my system but I had manually copied the freenas-v1.db from /data/freenas-v1.db before attempting the update. On boot up I get a bunch of errors and at the end all I get is a blinking cursor. I thought this would be a good time to get some experience with importing my pool and my config into a new install. So I installed 11U4 on a different USB stick but when I try to Upload Config, all I get is on the top of the screen. I don't see anything changing in the console at all after trying to upload the old config.
How would I upload my old config to this new install? Or would I have to just bite the bullet and re-configure everything from scratch?
I haven't tried importing my tank yet.
System specs:
MB : Tyan S5533
CPU: Pentium G3240
RAM: 16GB Crucial ECC Unbuffered RAM
PSU: Corsair CS450M
old boot disk: HP 16gb USB
new boot disk : Sandisk 8gb USB
Code:
An error occurred
How would I upload my old config to this new install? Or would I have to just bite the bullet and re-configure everything from scratch?
I haven't tried importing my tank yet.
System specs:
MB : Tyan S5533
CPU: Pentium G3240
RAM: 16GB Crucial ECC Unbuffered RAM
PSU: Corsair CS450M
old boot disk: HP 16gb USB
new boot disk : Sandisk 8gb USB
Last edited: