victorhooi
Contributor
- Joined
- Mar 16, 2012
- Messages
- 184
Hi,
I have a Dell R730XD server, and I'm trying to boot FreeNAS on it. The machine has been updated to the latest Dell firmware (as of October 2019).
I've tried with both FreeNAS 11.2-U6, as well as the latest nightly FreeNAS 11.3 ISO, and neither seem to boot up.
This is the console output from the installer:
Any ideas what is going on?
Thanks,
Victor
I have a Dell R730XD server, and I'm trying to boot FreeNAS on it. The machine has been updated to the latest Dell firmware (as of October 2019).
I've tried with both FreeNAS 11.2-U6, as well as the latest nightly FreeNAS 11.3 ISO, and neither seem to boot up.
This is the console output from the installer:
Code:
usbd_setup_device_desc: getting device descriptor at addr 2 failed, USB_ERR_TIMEOUT usbd_req_re_enumerate: addr=2, set address failed! (USB_ERR_TIMEOUT, ignored) usbd_req_re_enumerate: addr=2, set address failed! (USB_ERR_TIMEOUT, ignored) usbd_setup_device_desc: getting device descriptor at addr 2 failed, USB_ERR_TIMEOUT usbd_setup_device_desc: getting device descriptor at addr 2 failed, USB_ERR_TIMEOUT usbd_req_re_enumerate: addr=2, set address failed! (USB_ERR_TIMEOUT, ignored) usbd_req_re_enumerate: addr=2, set address failed! (USB_ERR_TIMEOUT, ignored) usbd_setup_device_desc: getting device descriptor at addr 2 failed, USB_ERR_TIMEOUT ugen1.2: <Unknown > at usbus1 (disconnected) usbd_setup_device_desc: getting device descriptor at addr 2 failed, USB_ERR_TIMEOUT ugen0.2: <Unknown > at usbus1 (disconnected) uhub_reattach_port: could not allocate new device uhub_reattach_port: could not allocate new device mrsas0: Initiating Target RESET because of SCSI IO timeout! mrsas0: target reset FAIL!! mrsas0: Initiating OCR because of TM FAILURE! mrsas0: [ 0]waiting for 269 commands to complete mrsas0: Reset Exit with 0. random: unblocking device mrsas0: Initiating Target RESET because of SCSI IO timeout! mrsas0: Task management NOT SUPPORTED for CAM target:0 mrsas0: target reset FAIL!! mrsas0: Initiating OCR because of TM FAILURE! mrsas0: [ 0]waiting for 14 commands to complete mrsas0: Disestablish mrsas intr hook mrsas0: Reset Exit with 0 run_interrupt_driven_hooks: still waiting after 60 seconds for xpt_config run_interrupt_driven_hooks: still waiting after 120 seconds for xpt_config run_interrupt_driven_hooks: still waiting after 180 seconds for xpt_config mrsas0: Initiating Target RESET because of SCSI IO timeout! mrsas0: target reset FAIL!! mrsas0: Initiating OCR because of TM FAILURE! mrsas0: [ 0]waiting for 14 commands to complete
Any ideas what is going on?
Thanks,
Victor