I am using "FreeNAS-8.3.0-RELEASE-p1-x64 (r12825)". I am trying to import 2 ntfs disk, 2tb & 3tb.
Here are the steps i did:
I reset the FreeNAS to factory default and tried the set again 3 times. But same issue.
I tried a solution i found on http://support.freenas.org/ticket/759. But when i input "cp /usr/local/modules/fuse.ko /boot/kernel/" I got the error that the directory does not exist.
I am lost and clue less as to what to do.
P.S.: I am a newbie to freenas
Here are the steps i did:
- Enabled CIFS in "Services".
- "Storage>Import Volume" & choose NTFS. I imported 3tb successfully first. But the status is shown "UNKNOWN".
- I tried to do it for 2tb, but i get the error "An error occurred while labeling the disk.".
I reset the FreeNAS to factory default and tried the set again 3 times. But same issue.
I tried a solution i found on http://support.freenas.org/ticket/759. But when i input "cp /usr/local/modules/fuse.ko /boot/kernel/" I got the error that the directory does not exist.
I am lost and clue less as to what to do.
P.S.: I am a newbie to freenas