BillCardiff
Explorer
- Joined
- May 13, 2014
- Messages
- 59
Does the booting USB or the intended target USB save logs ?
After a power outage, the system is failing to reload. I am trying to figure out where to look to rebuild.
I created a new boot USB, and hunted down a new target USB. The system now reboots while creating the target when it's "loading the base OS" every time between 60 and 70 percent mark. Hoping I can use that to figure out what has failed in my system. Is it doing something specific at that point ? Maybe a RAM test, port check, hard drive check ? I know this isn't really helpful. Looking for any input or suggestions on what to check and where to look.
supermicro X8DTE
Xeon L5630 (pair)
96G RAM
12 hard drives across two flashed controllers
After a power outage, the system is failing to reload. I am trying to figure out where to look to rebuild.
I created a new boot USB, and hunted down a new target USB. The system now reboots while creating the target when it's "loading the base OS" every time between 60 and 70 percent mark. Hoping I can use that to figure out what has failed in my system. Is it doing something specific at that point ? Maybe a RAM test, port check, hard drive check ? I know this isn't really helpful. Looking for any input or suggestions on what to check and where to look.
supermicro X8DTE
Xeon L5630 (pair)
96G RAM
12 hard drives across two flashed controllers