vascosa
Cadet
- Joined
- Nov 21, 2021
- Messages
- 1
Here's my current set-up:
Motherboard: X10SLL-F
RAM: 8GB DDR3 ECC UDIMM RAM PC3-12800E
Processor: Intel® Xeon® E3-1270 v3
This is a new setup, and I am trying to access the BIOS to change the boot order and install the OS, but am getting no video output.
IPMI works, but iKVM shows no display. Direct VGA connection via the back of the board also shows nothing (the jumpers is in the correct setting).
I have tried all I could remember: reinstall CPU, change RAM slots, reset CMOS, change monitors, I even tried using an old RADEON X600XT (with and without onboard video jumper enabled). Nothing works.
Any help or suggestions are greatly appreciated!
Motherboard: X10SLL-F
RAM: 8GB DDR3 ECC UDIMM RAM PC3-12800E
Processor: Intel® Xeon® E3-1270 v3
This is a new setup, and I am trying to access the BIOS to change the boot order and install the OS, but am getting no video output.
IPMI works, but iKVM shows no display. Direct VGA connection via the back of the board also shows nothing (the jumpers is in the correct setting).
I have tried all I could remember: reinstall CPU, change RAM slots, reset CMOS, change monitors, I even tried using an old RADEON X600XT (with and without onboard video jumper enabled). Nothing works.
Any help or suggestions are greatly appreciated!