Hi all, this is my first post and sorry for my bad english.
I've installed FreeNAS 9.10.1 and I have some issues with the network configuration, an example:
I add the interface igb0=10.0.1.10/24 and Default Route=10.0.1.1 and I can access the GUI and connect with SSH from my computer=192.168.5.20/24. But when I add the interface igb1=192.168.5.5/24, I can't connect with SSH to igb0, it gets stuck when I try to connect, and after 5-10 minutes, I can't access the GUI. Only I can connect with SSH and access the GUI from the new interface.
I have enabled SSH service without binding any interface, so it would be listening to all interfaces, and WebGUI Ipv4 Address is 0.0.0.0
If I use telnet 10.0.1.10 22, I get this:
Trying 10.0.1.10...
Connected to 10.0.1.10
Escape character is '^]'
If I were connected that command shouldn't reply the used SSH protocol too?
Could you help me please?
I've installed FreeNAS 9.10.1 and I have some issues with the network configuration, an example:
I add the interface igb0=10.0.1.10/24 and Default Route=10.0.1.1 and I can access the GUI and connect with SSH from my computer=192.168.5.20/24. But when I add the interface igb1=192.168.5.5/24, I can't connect with SSH to igb0, it gets stuck when I try to connect, and after 5-10 minutes, I can't access the GUI. Only I can connect with SSH and access the GUI from the new interface.
I have enabled SSH service without binding any interface, so it would be listening to all interfaces, and WebGUI Ipv4 Address is 0.0.0.0
If I use telnet 10.0.1.10 22, I get this:
Trying 10.0.1.10...
Connected to 10.0.1.10
Escape character is '^]'
If I were connected that command shouldn't reply the used SSH protocol too?
Could you help me please?