Hello all,
I've just setup my FreeNAS(11.2-U4.1), on a Dell R620 with "onboard" Dual Gigabit and Dual 10GbE ports. I have an H310 Mini that was flashed to IT mode. I have one SSD zPool with 3 400GB(MO0400FCTRP), which provides storage via iSCSI to an ESXi 6.7U2 host and I'm noticing high utilization and high TRIM requests on the disks. I found the following thread: https://www.ixsystems.com/community/threads/ssd-pool-trim-missbehaving.55221/, but that was from 2 years ago and wasn't sure if there was any improvements I can make.
When looking at the TRIM stats, in under a week, it has done 3.5TBs, and I constantly get emails about 95% utilization for over 10 minutes that tracks with high TRIM requests.
Is there any changes I should make on my setup?
Side note: This is just a home lab, and I can be destructive to try any type of solution.
If I left out any information, please let me know!
Thank you!
I've just setup my FreeNAS(11.2-U4.1), on a Dell R620 with "onboard" Dual Gigabit and Dual 10GbE ports. I have an H310 Mini that was flashed to IT mode. I have one SSD zPool with 3 400GB(MO0400FCTRP), which provides storage via iSCSI to an ESXi 6.7U2 host and I'm noticing high utilization and high TRIM requests on the disks. I found the following thread: https://www.ixsystems.com/community/threads/ssd-pool-trim-missbehaving.55221/, but that was from 2 years ago and wasn't sure if there was any improvements I can make.
When looking at the TRIM stats, in under a week, it has done 3.5TBs, and I constantly get emails about 95% utilization for over 10 minutes that tracks with high TRIM requests.
Is there any changes I should make on my setup?
Side note: This is just a home lab, and I can be destructive to try any type of solution.
If I left out any information, please let me know!
Thank you!