[solved] WebGUI not reachable after mtu 9000

[icewaere]

Hi,

i have a little problem with webgui access freenas 9.3 ;/
i have set on webgui networksettings options:mtu 9000
now i cant access Webgui ;/

i have try to edit /etc/rc.conf but is empty ;/ and ifconfig em0 ip mtu 1500 but dont change that ;/

i have reset network interface and config new with VNC shell but dont works to change mtu to 1500.

wich file i must edit to change network options to del mtu 9000?

hope anyone can hlp me without setup freenas new for this little misstake.

regards ice

 

[cyberjock]

Uh.. the two ways I know of are to default you system, or setup a temporary network that does handle the mtu 9000 and log into the FreeNAS server and remove the extra MTU setting.

 

[Noctris]

Do you have physical access to the machine? You could fix it through ifconfig or worst case delete the interface and reconfigure?

Sent from my portable microwave

 

[Noctris]

http://www.cyberciti.biz/faq/freebsd-jumbo-frames-networking-configration/ and set it back to 1500

Sent from my portable microwave

 

[jgreco]

http://www.cyberciti.biz/faq/freebsd-jumbo-frames-networking-configration/ and set it back to 1500

"ifconfig em0 mtu 1500" (if it's em0).

Sent from my portable microwave

By the way, I hope you're not using that as a hat.

 

[Noctris]

"ifconfig em0 mtu 1500" (if it's em0).



By the way, I hope you're not using that as a hat.

Nah.. just keep it to my ears from time to time when i feeld cold :)

Sent from my portable microwave

 

[icewaere]

Hi,

thx for all response!
i can fix it with VNC shell access ;)

"ifconfig em0 mtu 1500"

after that i have access again to WebGUI and can delete the wrong Interface Options ;)

regards ice