Hello
I recently replaced a failed drive, re-silvering commenced as expected but the old drive still shows up as Unavailable in the volume status window. Under Available Actions I have only the Detach button for this unavailable drive and if I press it it gives me the pop up message 'Disk detach has been successfully done'. All good so far but when I reload Volume Status tab the drive is still there. After I reboot, the drive is still there!
Is there a command line I should run to make the damn offline drive disappear?
Re silvering process is still ongoing.
One more question if I may: if I restart the system during resilvering, the process is continued from where was left or is completely restarted?
Thank you
I recently replaced a failed drive, re-silvering commenced as expected but the old drive still shows up as Unavailable in the volume status window. Under Available Actions I have only the Detach button for this unavailable drive and if I press it it gives me the pop up message 'Disk detach has been successfully done'. All good so far but when I reload Volume Status tab the drive is still there. After I reboot, the drive is still there!
Is there a command line I should run to make the damn offline drive disappear?
Re silvering process is still ongoing.
One more question if I may: if I restart the system during resilvering, the process is continued from where was left or is completely restarted?
Thank you