Darren Myers
Guru
- Joined
- Oct 2, 2014
- Messages
- 925
I received an alert from FreeNAS that "Device: /dev/da11 [SAT], Self-Test Log error count increased from 0 to 1"
I have since ordered a replacement and it arrives today, I am curious the best way to replace it, whether I should go into the WebGUI force it offline, and then insert the new drive; or power down, replace ,power on.
Spec's:
FreeNAS-9.10.1 (d989edd)
Supermicro X9DR3-LN4F+ , dual E5-2670 @ 2.60Ghz
96GB of RAM
9211-8i , IT Phase 20
Dual 80GB Intel SSD's for boot
x7 4TB WD Red's RAIDz3
x14 2TB WD RE4's Striped RAIDz3
x14 2TB WD RE4's Striped RAIDz3
Chelsio T420-CR 10GB card
Intel quad port gigabit NIC
Supermicro 847E16-R1400LPB case
The drive in question is apart of my x7 4Tb harddrives in RAIDz3.
I have since ordered a replacement and it arrives today, I am curious the best way to replace it, whether I should go into the WebGUI force it offline, and then insert the new drive; or power down, replace ,power on.
Spec's:
FreeNAS-9.10.1 (d989edd)
Supermicro X9DR3-LN4F+ , dual E5-2670 @ 2.60Ghz
96GB of RAM
9211-8i , IT Phase 20
Dual 80GB Intel SSD's for boot
x7 4TB WD Red's RAIDz3
x14 2TB WD RE4's Striped RAIDz3
x14 2TB WD RE4's Striped RAIDz3
Chelsio T420-CR 10GB card
Intel quad port gigabit NIC
Supermicro 847E16-R1400LPB case
The drive in question is apart of my x7 4Tb harddrives in RAIDz3.