Hey all. When I set up my box 18 months ago, the only option I had at the time for the quantity of disks I needed was to order from a single vendor. So, currently, I'm running 15 disks from the same lot. I've been acquiring new disks from different vendors with staggered lot numbers over the last couple of months and I would like to replace the working disks with the tested new staggered lot disks.
Reading the manual, it covers replacing failed disks, and I just want to confirm the procedure is the same for replacing perfectly fine, working disks.
(RaidZ2 configuration) From Volume Status, select disk to be replaced > Offline > Insert new disk > Click Replace disk > Select new disk
Correct? Or is there a better way? Can I resilver to another disk in the chassis without physically removing the working disk until the resilver is complete?
Reading the manual, it covers replacing failed disks, and I just want to confirm the procedure is the same for replacing perfectly fine, working disks.
(RaidZ2 configuration) From Volume Status, select disk to be replaced > Offline > Insert new disk > Click Replace disk > Select new disk
Correct? Or is there a better way? Can I resilver to another disk in the chassis without physically removing the working disk until the resilver is complete?
Last edited: