Chamrajnagar
Explorer
- Joined
- Jan 2, 2015
- Messages
- 89
I built a FreeNAS box around 4 years ago.
Supermicro MBD-A1SAi-2750F-O which has an embedded Atom C2750.
1 x 8GB Kingston KVR16LSE11/8 ECC RAM
I had FreeNAS running on 192.168.1.100 and the Supermicro IMPI port on 192.168.1.150.
192.168.150 still shows up, but 192.168.1.100 has disappeared, telling me there is an issue booting into FreeNAS.
I can still ssh into my server on 192.168.1.150, and navigate to sol1. However when I type the command 'start' I get the following, but no command prompt:
/system1/sol1
press <Enter>, <Esc>, and then <T> to terminate session
(press the keys in sequence, one after the other)
Networking isn't my specialty, and I only run into issues with my FreeNAS box sporadically, so I never remember how to fix it.
What should my next steps be in attempting to diagnose the problem?
Thanks!
Supermicro MBD-A1SAi-2750F-O which has an embedded Atom C2750.
1 x 8GB Kingston KVR16LSE11/8 ECC RAM
I had FreeNAS running on 192.168.1.100 and the Supermicro IMPI port on 192.168.1.150.
192.168.150 still shows up, but 192.168.1.100 has disappeared, telling me there is an issue booting into FreeNAS.
I can still ssh into my server on 192.168.1.150, and navigate to sol1. However when I type the command 'start' I get the following, but no command prompt:
/system1/sol1
press <Enter>, <Esc>, and then <T> to terminate session
(press the keys in sequence, one after the other)
Networking isn't my specialty, and I only run into issues with my FreeNAS box sporadically, so I never remember how to fix it.
What should my next steps be in attempting to diagnose the problem?
Thanks!