Hello,
My new server build saga continues. After finally getting Corral working, it was effectively canceled. So, off to 9.10.2 U3.
I have 9.10.2 U3 installed, and everything looks good.
Now, I go to plugins and install a few, SabNZB, SickRage, and Plex. After the pulgins are installed, I go to the “Installed” tab under plugins, and it takes upwards of three minutes to load. Once it loads, all Plugins show as “Off”. If I try to enable any of them, they fail.
If I go to the jails, stop all three jails, then go back to Plugins -> Installed, it loads almost immediately. The plugins are of course are off at this point.
I have confirmed my network settings etc. After playing around for a while, I figured it was a new install maybe it is corrupt. So, I reinstall FreeNAS using the “Format” option to ensure a clean install is done.
FreeNas boots up, I configure new users, storage is visible, etc. Add a plugin, and bam, it happens again?
I am at a total loss here.
Anyone have any ideas?
System Specs:
OS: FreeNAS FreeNAS-9.10.2-U3 (e1497f269)
MB: SuperMicro MBD-X11SSL-F
CPU: Intel Xeon E3-1230 v5 SkyLake
RAM: 32GB Kingston Value 288-Pin DDR4 SDRAM ECC Registered DDR4 2400
My new server build saga continues. After finally getting Corral working, it was effectively canceled. So, off to 9.10.2 U3.
I have 9.10.2 U3 installed, and everything looks good.
Now, I go to plugins and install a few, SabNZB, SickRage, and Plex. After the pulgins are installed, I go to the “Installed” tab under plugins, and it takes upwards of three minutes to load. Once it loads, all Plugins show as “Off”. If I try to enable any of them, they fail.
If I go to the jails, stop all three jails, then go back to Plugins -> Installed, it loads almost immediately. The plugins are of course are off at this point.
I have confirmed my network settings etc. After playing around for a while, I figured it was a new install maybe it is corrupt. So, I reinstall FreeNAS using the “Format” option to ensure a clean install is done.
FreeNas boots up, I configure new users, storage is visible, etc. Add a plugin, and bam, it happens again?
I am at a total loss here.
Anyone have any ideas?
System Specs:
OS: FreeNAS FreeNAS-9.10.2-U3 (e1497f269)
MB: SuperMicro MBD-X11SSL-F
CPU: Intel Xeon E3-1230 v5 SkyLake
RAM: 32GB Kingston Value 288-Pin DDR4 SDRAM ECC Registered DDR4 2400