Mats Larsson
Cadet
- Joined
- Sep 29, 2016
- Messages
- 3
Here is a short description of my problem.
I have a working environment with 2 xenserver 7.0, 2 tp-link 1GB switches, 1 freenas and a qnap.
I want to get rid of my qnap ang go for 10GB in 2 Freenas.
I bought new intel 10 GB NIC ( X540T2) .
I added the new NIC:s in xenserver, connected them to my old 1 GB switch from TP-Link (TL-SG2216) and it works fine.
Now my new switch from D-link arrives and my problem starts.
I configure the switches and when i try to create new SR in xencenter i can scan my target host and see my iscsi target in xencenter, but the LUN don't show up.
If i then connect this to my old TP-link switches, it works fina again.
The question is: What am i doing wrong in the D-link switches ?
I have a working environment with 2 xenserver 7.0, 2 tp-link 1GB switches, 1 freenas and a qnap.
I want to get rid of my qnap ang go for 10GB in 2 Freenas.
I bought new intel 10 GB NIC ( X540T2) .
I added the new NIC:s in xenserver, connected them to my old 1 GB switch from TP-Link (TL-SG2216) and it works fine.
Now my new switch from D-link arrives and my problem starts.
I configure the switches and when i try to create new SR in xencenter i can scan my target host and see my iscsi target in xencenter, but the LUN don't show up.
If i then connect this to my old TP-link switches, it works fina again.
The question is: What am i doing wrong in the D-link switches ?