Hi,
Recently bought an IBM m1015 SAS addon card, to expand the NAS a little.
I flashed the card to IT mode, which seemed to go perfectly, but when I insert the card into my NAS, it seems to hang during booting. In fact it boots up until the point where it states "Checking NVRAM", this should only take like a second, but the NAS hangs here.
If i take the card out, the NAS boots as normal, I have already tried resetting bios, changing various options in bios (disable ecc, disable onboard devices, load defaults, ...) but none of these things seem to work.
In another PC the SAS card works normally.
Motherboard is an ASUS M3A76-CM.
Any thoughts or ideas?
Recently bought an IBM m1015 SAS addon card, to expand the NAS a little.
I flashed the card to IT mode, which seemed to go perfectly, but when I insert the card into my NAS, it seems to hang during booting. In fact it boots up until the point where it states "Checking NVRAM", this should only take like a second, but the NAS hangs here.
If i take the card out, the NAS boots as normal, I have already tried resetting bios, changing various options in bios (disable ecc, disable onboard devices, load defaults, ...) but none of these things seem to work.
In another PC the SAS card works normally.
Motherboard is an ASUS M3A76-CM.
Any thoughts or ideas?