Hello
After a reboot the 10G card is half recognized and did not work. On the truenas ui under network interfaces the melanox interface type is UNKNOWN and there is no link state (all other parameters as usual)
The card did not apear in ifconfig only re0, lo0 and pflog0
Is there any way to have the state of the card or restart it ?
Also the update do not work but this can be due to my janky router config
Thank you for the help !
The 10g link consist of two same card and 1m copper cable from nas to windows 10 and working before the reboot.
TrueNAS-12.0-U3
MCX311A-XCAT CX311A ConnectX - 3
LSI SAS 2008 - 1pool - 8x2TO sata drives
128 Go pci-e x4 cache drive
msi Z77a-g43 - 1pool - 6x2TO sata drives
i5 2500k (Previous gaming build ^^)
After a reboot the 10G card is half recognized and did not work. On the truenas ui under network interfaces the melanox interface type is UNKNOWN and there is no link state (all other parameters as usual)
The card did not apear in ifconfig only re0, lo0 and pflog0
Is there any way to have the state of the card or restart it ?
Also the update do not work but this can be due to my janky router config
Thank you for the help !
The 10g link consist of two same card and 1m copper cable from nas to windows 10 and working before the reboot.
TrueNAS-12.0-U3
MCX311A-XCAT CX311A ConnectX - 3
LSI SAS 2008 - 1pool - 8x2TO sata drives
128 Go pci-e x4 cache drive
msi Z77a-g43 - 1pool - 6x2TO sata drives
i5 2500k (Previous gaming build ^^)
