I am trying to do a manual send and receive between two boxes via command line. I usually do an initial ZFS send and then send incremental after that.
After I send the initial stream I set the filesystem to read only on the destination.
But when I send the incremental I get:
cannot receive incremental stream: destination eh/data has been modified
since most recent snapshot
The send box is OpenIndiana and receive is FreeNAS.
After I send the initial stream I set the filesystem to read only on the destination.
But when I send the incremental I get:
cannot receive incremental stream: destination eh/data has been modified
since most recent snapshot
The send box is OpenIndiana and receive is FreeNAS.