Hi!
Warning I'm new to Networking. Always keen to learn though.
I recently swapped out my ISP provided router to improve signal strength. I may have been optimistic and hoped that the Static IP would have worked on the new router. Better yet, when I realised I could plug into the old router and connect I should have created a backup/snapshot but that's why we learn!
I plugged back into my new router, hoping that I would be able to re-configure the static IP address - unfortunately when I pressed 1 to do this it didn't work. I then noticed "Reset Configuration to defaults" I assumed this would mean the IP address etc and pressed 8. My mistake. I can now access my NAS but my pools are missing - I haven't got as far as my other settings. It's not mission critical, 90% of the data is backed up elsewhere - but there's some that we found unexpectedly that I can't find any further back ups off that I would really like to retrieve.
I have tried to find help in the forum and come across the following commands which give me this:
zpool Status
zpool list:
zpool import:
When I try the Auto import way through the Web UI it doesn't find the pools to import. After I've done this I still have no pools found.
Any guidance or support will be really appreciated. Sorry re the computer specs in my sig - I don't know much more than that without dismantling my computer again
Warning I'm new to Networking. Always keen to learn though.
I recently swapped out my ISP provided router to improve signal strength. I may have been optimistic and hoped that the Static IP would have worked on the new router. Better yet, when I realised I could plug into the old router and connect I should have created a backup/snapshot but that's why we learn!
I plugged back into my new router, hoping that I would be able to re-configure the static IP address - unfortunately when I pressed 1 to do this it didn't work. I then noticed "Reset Configuration to defaults" I assumed this would mean the IP address etc and pressed 8. My mistake. I can now access my NAS but my pools are missing - I haven't got as far as my other settings. It's not mission critical, 90% of the data is backed up elsewhere - but there's some that we found unexpectedly that I can't find any further back ups off that I would really like to retrieve.
I have tried to find help in the forum and come across the following commands which give me this:
zpool Status
Code:
pool: boot-pool state: ONLINE scan: scrub repaired 0B in 00:00:27 with 0 errors on Sat Feb 19 19:45:27 2022 config: NAME STATE READ WRITE CKSUM boot-pool ONLINE 0 0 0 ada0p2 ONLINE 0 0 0 errors: No known data errors
zpool list:
Code:
NAME SIZE ALLOC FREE CKPOINT EXPANDSZ FRAG CAP DEDUP HEALTH ALTROOT boot-pool 448G 1.44G 447G - - 0% 0% 1.00x ONLINE -
zpool import:
Code:
# zpool import pool: Vault 0.1 id: 13631882240467607633 state: ONLINE action: The pool can be imported using its name or numeric identifier. config: Vault 0.1 ONLINE mirror-0 ONLINE gptid/a73f2724-8a87-11ec-a9d0-902b34a3eb13 ONLINE gptid/a730836b-8a87-11ec-a9d0-902b34a3eb13 ONLINE # zpool import Vault 0.1 cannot import 'Vault': no such pool available # Zpool Import # zpool import 13631882240467607633
When I try the Auto import way through the Web UI it doesn't find the pools to import. After I've done this I still have no pools found.
Any guidance or support will be really appreciated. Sorry re the computer specs in my sig - I don't know much more than that without dismantling my computer again