the_freenas_noob
Dabbler
- Joined
- Apr 11, 2014
- Messages
- 13
Hi Everyone,
I'm brand new to FreeNAS, attempting my first build.
I've configured my hardware as follows:
Gigabyte EQ45M-S2 MoBo
2x 1TB 3.5" HDDs
4x 1TB 2.5" HDDs
ServeRaid m1015 Card (LSI chip)
4GB RAM
16GB USB stick
onboard gig-e NIC & VGA
Due to the way my hardware is set up, I have 4 drives connected to the motherboard's SATA ports and 2 connected to the SAS port 0 on the m1015. The BIOS only gives me the option of setting the ports to AHCI or RAID, but I have enabled native IDE on ports 0-3 (where the HDDs are connected). I also tried without setting the native IDE option, and still got the problem below.
Essentially the system seems to start booting OK, but then very briefly shows the setup screen (with the FREENAS text and options 1-5). I almost immediately goes into a kernel panic, with the following message:
And it gives me a prompt.
I've found very little Googling this error, so I would really appreciate a steer on how to move forward.
Thanks!
I'm brand new to FreeNAS, attempting my first build.
I've configured my hardware as follows:
Gigabyte EQ45M-S2 MoBo
2x 1TB 3.5" HDDs
4x 1TB 2.5" HDDs
ServeRaid m1015 Card (LSI chip)
4GB RAM
16GB USB stick
onboard gig-e NIC & VGA
Due to the way my hardware is set up, I have 4 drives connected to the motherboard's SATA ports and 2 connected to the SAS port 0 on the m1015. The BIOS only gives me the option of setting the ports to AHCI or RAID, but I have enabled native IDE on ports 0-3 (where the HDDs are connected). I also tried without setting the native IDE option, and still got the problem below.
Essentially the system seems to start booting OK, but then very briefly shows the setup screen (with the FREENAS text and options 1-5). I almost immediately goes into a kernel panic, with the following message:
Code:
Booting... KDB: debugger backends: ddb KDB: current debugger: dds panic: BIOS smap did not include a basemem segment! cpuid = 0 KDB: stack backtrace: [NOT TYPED DUE TO COMPLEXITY] KDB: enter: panic
And it gives me a
Code:
db>
I've found very little Googling this error, so I would really appreciate a steer on how to move forward.
Thanks!