Jail forward IP

[DrewS]

I have an owncloud jail that I can access on my local network in the browser. Inside my router D-Link DIR655 it shows the freenas IP 192.168.0.150 but does not show the owncloud jail 192.168.0.151. Again I access the site on the local network, and I can access the freenas from an external IP but not the owncloud one.

I need to get the jail IP to show in my router so I can setup the virtual server inside router, and then external IP so I can access them from outside the local network.

 

[mrreload]

If your D-Link router truly requires that it's managing the IP of the Jail, via DHCP I assume, then get rid of that router.
From my experience, I have never seen a router that requires this for port forwarding to (virtual server) an internal host. You should be able to just manually type in the IP address.

 

[SweetAndLow]

I have no clue what mrreload is talking about. The setting in your router you want to look for is called port forwarding.

This thread might help
http://forum.owncloud.org/viewtopic.php?f=26&t=21251

 

[mrreload]

the OP said "I need to get the jail IP to show in my router so I can setup the virtual server inside router".
I have never seen a router that required what the OP stated for port forwarding.
Instead of directing him to the OwnCloud website perhaps his router manual's router would be more appropriate?
http://www.dlink.com/-/media/Consumer_Products/DIR/DIR 655/Manuels/DIR655B1manual070312v23pdf.pdf
The sections for Virtual Servers, Port Forwarding are a bit wonky though.