1337Hacker
Dabbler
- Joined
- Oct 22, 2017
- Messages
- 27
So I finally got a iocage jail to install through the CLI, but I couldn't get vnet to work. I chose nfe0 which may be causing my issue:
This is my output for the vnet attempt in case anyone was wondering
ifconfig below
The issue is now 10.0.0.6 is displaying as a gateway for my NAS and opens the GUI in browser. Does anyone have suggestions because I've looked through a number of posts regarding iocage installation and this is skimmed over.
Code:
iocage create -n "plex" -p /tmp/pkg.json -r 11.1-RELEASE ip4_addr="nfe0|10.0.0.6/24" defaultrouter="10.0.0.5" allow_raw_sockets="1" boot="on"
This is my output for the vnet attempt in case anyone was wondering
Code:
iocage create -n "plex" -p /tmp/pkg.json -r 11.1-RELEASE ip4_addr="vnet0|10.0.0.6/24" defaultrouter="10.0.0.5" vnet="on" allow_raw_sockets="1" boot="on" plex successfully created! Testing SRV response to FreeBSD Error: error sending query: General LDNS error {repo} could not be reached, please check your DNS
ifconfig below
Code:
nfe0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=8210b<RXCSUM,TXCSUM,VLAN_MTU,TSO4,WOL_MAGIC,LINKSTATE> ether 00:22:15:46:5c:b2 hwaddr 00:22:15:46:5c:b2 inet 10.0.0.5 netmask 0xffffff00 broadcast 10.0.0.255 inet 10.0.0.6 netmask 0xffffff00 broadcast 10.0.0.255 nd6 options=9<PERFORMNUD,IFDISABLED> media: Ethernet autoselect (1000baseT <full-duplex>) status: active lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384 options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6> inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2 inet 127.0.0.1 netmask 0xff000000 nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL> groups: lo bridge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 ether 02:88:8c:df:d4:00 nd6 options=9<PERFORMNUD,IFDISABLED> groups: bridge id 00:00:00:00:00:00 priority 32768 hellotime 2 fwddelay 15 maxage 20 holdcnt 6 proto rstp maxaddr 2000 timeout 1200 root id 00:00:00:00:00:00 priority 32768 ifcost 0 port 0
The issue is now 10.0.0.6 is displaying as a gateway for my NAS and opens the GUI in browser. Does anyone have suggestions because I've looked through a number of posts regarding iocage installation and this is skimmed over.
Last edited: