Hello, this is my "server" configuration:
- Supermicro X10SRA-F
- Intel Xeon 2695v4
- 4x8GB DDR4 2133 ECC-REG
- 8x8TB Wd RED in RAIDZ-2 configuration
- NIC Intel X520-DA2
- FreeNAS 11.2
I use only one interface on X520-DA2 NIC (I configured with static ip address, netmask and gateway), but when I restart (or power off and power on) the server, I can not reach the GUI, and it works only if I swap the transceiver to the other interface. If I restart again I must swap again the cable. It's like the system could not "remember" which interface is configurated.
Thanx in advance for your support (sorry for my bad English)
- Supermicro X10SRA-F
- Intel Xeon 2695v4
- 4x8GB DDR4 2133 ECC-REG
- 8x8TB Wd RED in RAIDZ-2 configuration
- NIC Intel X520-DA2
- FreeNAS 11.2
I use only one interface on X520-DA2 NIC (I configured with static ip address, netmask and gateway), but when I restart (or power off and power on) the server, I can not reach the GUI, and it works only if I swap the transceiver to the other interface. If I restart again I must swap again the cable. It's like the system could not "remember" which interface is configurated.
Thanx in advance for your support (sorry for my bad English)