Stuart Rowe
Cadet
- Joined
- Nov 4, 2016
- Messages
- 2
Hello,
I am trying to install FreeNAS 11 as a fresh install on the following system:
Supermicro SC836 chassis
6x500GB, 8x1TB and 2x80GB hard drives
X7DBE Motherboard
2x Xeon 3GHz dual core processors
16GB RAM
Adaptec SAS 51645 controller
The issue I am running into is after I boot off of the USB drive and attempt to install to the RAID-0 array of 2x80GB drives, everything goes OK until the install its 60%. As soon as it hits 60%, the entire system reboots without a bootable install present. I have reproduced this issue going CD to USB (Sandisk Cruzer Glide 16GB) as well as USB to USB (Sandisk Cruzer to Sandis Cruzer Glide). This system installs other OS' without issues. Is there anything I can look at that might be causing the FreeNAS installer to bug out as I have seen? I have not been able to find much around this hardware or the issue I seem to be running into... Thanks!
I am trying to install FreeNAS 11 as a fresh install on the following system:
Supermicro SC836 chassis
6x500GB, 8x1TB and 2x80GB hard drives
X7DBE Motherboard
2x Xeon 3GHz dual core processors
16GB RAM
Adaptec SAS 51645 controller
The issue I am running into is after I boot off of the USB drive and attempt to install to the RAID-0 array of 2x80GB drives, everything goes OK until the install its 60%. As soon as it hits 60%, the entire system reboots without a bootable install present. I have reproduced this issue going CD to USB (Sandisk Cruzer Glide 16GB) as well as USB to USB (Sandisk Cruzer to Sandis Cruzer Glide). This system installs other OS' without issues. Is there anything I can look at that might be causing the FreeNAS installer to bug out as I have seen? I have not been able to find much around this hardware or the issue I seem to be running into... Thanks!