melloa
Wizard
- Joined
- May 22, 2016
- Messages
- 1,749
Got couple of H200 to flash and looking at the instructions it says to cover pins B5 and B6 on H310 if your computer won't boot.
As mine are H200, should I cover those pins if my computer won't boot? I will flashing on another computer, not the FreeNAS box, so won't cut them (I don't like to use electrical tape, they can cause future problems with re-seating the card and tearing the tape a little bit, causing the contact to close), after flash is finished and they are tested on the FreeNAS box, but wanted to be sure that's applicable for H200.
Thanks!
As mine are H200, should I cover those pins if my computer won't boot? I will flashing on another computer, not the FreeNAS box, so won't cut them (I don't like to use electrical tape, they can cause future problems with re-seating the card and tearing the tape a little bit, causing the contact to close), after flash is finished and they are tested on the FreeNAS box, but wanted to be sure that's applicable for H200.
Thanks!