statik
Explorer
- Joined
- Sep 8, 2013
- Messages
- 71
Was watching a show on my FreeNAS using Plex, finished the show went to get another then nothing would load. Tried to web into my FreeNAS to see if anything was wrong and was not able to, link to FreeNAS and Plex down. I checked my KVM attached to my FreeNAS and it was stuck in db>, so I did a reboot and it went back in to db>. Friend and from reading was instructed to shut down and reload FreeNAS (9.1.1 same version) on the thumb drive. Booted up into new load of FreeNAS on thumb drive fine. Now back into FreeNAS and of course my ZFS volume is not attached and all my configs are reset, as expected. From console I did a Camcontrol devlist (all drives look good), gpart show (looks good), glabel status (looks good), and then zpool import and my existing volume named Volume01 shows. So, I from the FreeNAS gui I ran the Auto Import Volume (Volume01 showed up and its not encrypted) yesterday and after 24 hours the little window with the scrolling blue stripe bar is still going. My friend said it should only take like an hour. So now we are tying to figure out what's going on. I X'ed out of that window and reboot, watched the bootup from my KVM and didn't see any errors and it bootup fine. I tried the Auto Import Volume again, and now its doing its thinking with the scrolling bar, it has been about an hour now.
Please help, I have about 3.5tb of video.
Please help, I have about 3.5tb of video.