StarkJohan
Explorer
- Joined
- Mar 27, 2015
- Messages
- 62
True. But when the BMC sets everything to 100% because a fan fails we have a problem. A few minutes later when the script notices this, it resets the BMC and sets fans to "script duty cycles", say 25%. Another few minutes later when the BMC finishes its reboot it sets the fan mode to FULL again and fans ramp up to 100%. A few moments later, the script runs and finds the fans are not on the intended RPM and resets the BMC...
Or do you mean that it might just be better to comment out the BMC reset part? Just trying to wrap my head around every possible scenario.
Even when the fan is replaced the loop continues and the script needs to be restarted.
Or do you mean that it might just be better to comment out the BMC reset part? Just trying to wrap my head around every possible scenario.
Even when the fan is replaced the loop continues and the script needs to be restarted.