Hello,
I need your help because I don't really know how to set this up. Searching the net didn't yield any useful results either.
I have the following problem:
Everything runs normally and there are no problems. Now in winter, when I open the window where my NAS is located, it is cold in the room. And then the following alarms constantly appear.
It's clear that you don't need to turn the 3 fans up so high because everything gets colder, but the alarms are annoying.
I found the following command on the net (I think it even comes from the forum here). It doesn't seem to work somehow or I'm implementing it incorrectly.
I have 3 fans connected to FAN2, FAN3 and FANA.
I am very grateful for any tips.
I need your help because I don't really know how to set this up. Searching the net didn't yield any useful results either.
I have the following problem:
Everything runs normally and there are no problems. Now in winter, when I open the window where my NAS is located, it is cold in the room. And then the following alarms constantly appear.
Code:
New alerts: * Fan FAN2 Deasserted Lower Non-recoverable going low : Reading 1200 < Threshold 200 RPM. * Fan FAN2 Deasserted Lower Critical going low : Reading 1200 < Threshold 400 RPM. * Fan FANA Deasserted Lower Critical going low : Reading 1900 < Threshold 500 RPM. * Fan FAN2 Asserted Lower Critical going low : Reading 0 < Threshold 400 RPM. * Fan FAN2 Asserted Lower Non-recoverable going low : Reading 0 < Threshold 200 RPM. * Fan FANA Asserted Lower Critical going low : Reading 500 < Threshold 500 RPM. * Fan FAN3 Asserted Lower Critical going low : Reading 400 < Threshold 400 RPM. * Fan FAN3 Deasserted Lower Critical going low : Reading 1400 < Threshold 400 RPM. * Fan FAN2 Deasserted Lower Non-recoverable going low : Reading 1200 < Threshold 200 RPM.
It's clear that you don't need to turn the 3 fans up so high because everything gets colder, but the alarms are annoying.
I found the following command on the net (I think it even comes from the forum here). It doesn't seem to work somehow or I'm implementing it incorrectly.
Code:
ipmitool raw 0x30 0x70 0x66 0x01 0x00 0x32
I have 3 fans connected to FAN2, FAN3 and FANA.
Code:
mynas001# ipmitool sensor | grep -E "^FAN|^CPU Temp" CPU Temp | 51.000 | degrees C | ok | 0.000 | 0.000 | 0.000 | 88.000 | 93.000 | 93.000 FAN1 | na | | na | na | na | na | na | na | na FAN2 | 1200.000 | RPM | ok | 200.000 | 400.000 | 600.000 | 1300.000 | 1400.000 | 1500.000 FAN3 | 600.000 | RPM | nc | 200.000 | 400.000 | 600.000 | 1600.000 | 1700.000 | 1800.000 FANA | 1900.000 | RPM | nc | 300.000 | 500.000 | 700.000 | 1900.000 | 2000.000 | 2100.000
I am very grateful for any tips.