JonnyAlpha
Contributor
- Joined
- Jul 12, 2012
- Messages
- 128
I have run into some trouble during a new build.
I setup a 3 x HDD ZFS RAIDZ volume with the name NAS, all went OK. I then made a fatal mistake and decided I wanted to change the name of the volume so I deleted the Volume by clicking the Detach Volume icon. This seemed to work fine but when I then tried to create the new volume it seemed to hang. I have the NAS box connected to a monitor and a few messages appeared which seemed to indicate a loss of communication? It seemed to sort itself out however I ended up with a volume with error messages in the Used / Available / Size columns when viewing volumes. The Alert Icon is flashing yellow with a message "Warning: The volume FreeNAS (ZFS) status is unknown.
I did a soft reset again and just got the same?
ANy ide how to solve this?
I setup a 3 x HDD ZFS RAIDZ volume with the name NAS, all went OK. I then made a fatal mistake and decided I wanted to change the name of the volume so I deleted the Volume by clicking the Detach Volume icon. This seemed to work fine but when I then tried to create the new volume it seemed to hang. I have the NAS box connected to a monitor and a few messages appeared which seemed to indicate a loss of communication? It seemed to sort itself out however I ended up with a volume with error messages in the Used / Available / Size columns when viewing volumes. The Alert Icon is flashing yellow with a message "Warning: The volume FreeNAS (ZFS) status is unknown.
I did a soft reset again and just got the same?
ANy ide how to solve this?