Dynamic NTFS import options?

[Alfred Melvin]

After upgrading to Freenas 9.1.1 my disks and/or Raidz2's are not available from import commands.
According to the manual this is an issue that will be addressed at a later time.
What would my options be at this point? I have several backups on clients and media.
Should I start with new raids using the same hard drives after cleaning them?
My signature states the hardware and equipment I'm working with.

 

[dlavigne]

What did you upgrade from? How does NTFS fit into the picture if you have a RAIDZ2?

 

[Alfred Melvin]

I've continued to read and solve this problem. The NTSF does not apply as you have stated. I've managed to get the volumes to show on the side bar but not under any storage tab. Read similar problem somewhere on the forum but haven't located their post or solution yet. Also files and raids are visible at the client computers.
I'll try to figure this out! Thanks for showing some interest, sometimes it seems us noobs are ignored. (Questions don't always make sense to veterans I guess.)