Hi,
I'm having a problem with my cpu fan.
I build my HomeNAS starting with 3non-PWM Fans, MB Supermicro X11SSM-F, 2x16G Samsung ECC, intel E3-1230v6, while i wait for the hdd i do a burnin to see if everything is ok, and cpu and ram stress finish without a single problem, the cpu fan work really good at slow rate when the temp was low and a litle high rate when the cpu temp went up, but the non-PWM fans do i litle noise so i change them with 3be quiet wing 3.
I do the change and the new fans go crazy spinning up and down and i use the ipmitool instructions on the forum, the 3fan run ok but the cpu went crazy always at max speed, i dont change nothing on cpu fan, why it went crazy?
I have cpu Fan on FAN1, like supermicro userguide instruction and the other 3 from FAN2 to FAN4.
I try to reset de bmc but without success...
What can i do?
Thanks
I'm having a problem with my cpu fan.
I build my HomeNAS starting with 3non-PWM Fans, MB Supermicro X11SSM-F, 2x16G Samsung ECC, intel E3-1230v6, while i wait for the hdd i do a burnin to see if everything is ok, and cpu and ram stress finish without a single problem, the cpu fan work really good at slow rate when the temp was low and a litle high rate when the cpu temp went up, but the non-PWM fans do i litle noise so i change them with 3be quiet wing 3.
I do the change and the new fans go crazy spinning up and down and i use the ipmitool instructions on the forum, the 3fan run ok but the cpu went crazy always at max speed, i dont change nothing on cpu fan, why it went crazy?
I have cpu Fan on FAN1, like supermicro userguide instruction and the other 3 from FAN2 to FAN4.
I try to reset de bmc but without success...
What can i do?
Thanks