Mack Hankins
Dabbler
- Joined
- Mar 11, 2015
- Messages
- 14
So I'm migrating an old NAS to new hardware. It's a Supermicro CSE-847 with a JBOD attached. What we've changed are the drives and controllers. Also, I feel it's relevant to mention that the motherboard is a X8DTE-F. The only other card installed is a dual 1gb intel NIC.
Old Hardware
2x Adaptec 6405
1x Adaptect 6445
Hitachi 1GB Sata 3.0 3Gb/s 7200 RPM
New Hardware
LSI 9207-8i HBA
LSI 9207-8e HBA
Seagate NAS HDD ST2000VN000
The problem is when I plug any of the SAS cables into the HBAs the system will not boot to the usb. I have legacy usb enabled and I've tried almost every combination of plugging in sets of drives. (e.g only the front plane or just the jbod etc). If there are no drives plugged into the HBA it will boot fine. The old usb was running 8.0x something and the new usb is the latest 9.3. Can you give me any suggestions as to what to try next?
Old Hardware
2x Adaptec 6405
1x Adaptect 6445
Hitachi 1GB Sata 3.0 3Gb/s 7200 RPM
New Hardware
LSI 9207-8i HBA
LSI 9207-8e HBA
Seagate NAS HDD ST2000VN000
The problem is when I plug any of the SAS cables into the HBAs the system will not boot to the usb. I have legacy usb enabled and I've tried almost every combination of plugging in sets of drives. (e.g only the front plane or just the jbod etc). If there are no drives plugged into the HBA it will boot fine. The old usb was running 8.0x something and the new usb is the latest 9.3. Can you give me any suggestions as to what to try next?