cannot apply changes in DISK-Software RAID

[oliaros]

FreeNAS 0.7.2 (revision 5266) i386-full
VIA692 AWRDACPI Intel Pentium III 512MiB RAM

i82555 10/100 media interface VIA 83C572 USB controller VIA 82C596B UDMA66
controller port=0 interface=0

---

1
Subject:
cannot apply changes in DISK-Software RAID

---

1
Description:
Hello out there,
my FreeNAS works fine for several years now. By accident I found an error
message in the DISK-SoftwareRaid TAB:
-----------------cut here------------------
Warning: You are going to delete a RAID volume. All data will get lost and
can not be recovered.
The configuration has been changed.
You must apply the changes in order for them to take effect.

Volume Name Type Size Status
raid1 1 Initializing Initializing Edit RAID Delete RAID
-----------------cut here------------------

The RAID does not seem to have a problem, it works fine. I just would like
to reset this, but I cannot apply the changes.


Any hints? Thanx, oliaros

 

[dlavigne]

Note that you want the NAS4Free forums (0.7 was rebranded as that moving forward).