Chessmaster
Cadet
- Joined
- Jun 3, 2016
- Messages
- 3
I have got a problem on a new installation of FreeNAS-9.10-STABLE-201605240427: Everything works fine and I can configure the system in the WebUI but after a while the USB stick with the installation of FreeNAS gets disconnected and therefore the system crashes. The console says:
After these messages the WebUI and the pc itself doesn't respond to any commands and I have to reset the pc to boot again.
The problem appears sometimes very fast after booting, sometimes after one hour. It appears when I am working in the WebUI but also if the system is just booted and is running without any interaction. I have tried any USB-ports (2.0 and 3.0) available and the problem occurs on all of them.
What can I do, to fix this?
If there are more information needed, will I be happy to provide them, if possible.
Code:
ugen0.2: <JetFlash> at usbus0 (disconnected) (da0:umass-sim0:0:0:0): WRITE(10). CDB: 2a 00 00 88 46 c6 00 00 04 00 umass0: at uhub0, port 2, addr 1 (disconnected) (da0:umass-sim0:0:0:0): CAM status CCB request completed with an error (da0:umass-sim0:0:0:0): Retrying command da0 at umass-sim0 bus 0 scbus7 target 0 lun 0 da0: <JetFlash Transcend 32GB 1.00> s/n [ID] detached (da0:umass-sim0:0:0:0): Periph destroyed ugen0.2: <JetFlash> at usbus0 umass0: <JetFlash Mass Storage Device, class 0/0, rev 2.10/10.75, addr 4> on usbus0 umass0: SCSI over Bulk-Only; quirks = 0x8100 umass0:7:0:-1: Attached to scbus7 da0 at umass-sim0 bus 0 scbus7 target 0 lun 0 da0: <JetFlash Transcend 32GB 1.00> Removable Direct Access SPC-4 SCSI device da0: Serial Number [ID] da0: 40.000MB/s transfers da0: 30144MB (61734912 512 byte sectors) da0: quirks=0x12<NO_6_BYTE,NO_RC16>
After these messages the WebUI and the pc itself doesn't respond to any commands and I have to reset the pc to boot again.
The problem appears sometimes very fast after booting, sometimes after one hour. It appears when I am working in the WebUI but also if the system is just booted and is running without any interaction. I have tried any USB-ports (2.0 and 3.0) available and the problem occurs on all of them.
What can I do, to fix this?
If there are more information needed, will I be happy to provide them, if possible.