cake maker
Dabbler
- Joined
- Oct 16, 2016
- Messages
- 13
Hi all.
I'm new to FreeNAS, and have so far done according to everything I've read in ordering and setting up parts for operation. I used two USB sticks, both 16gb, to first put the ISO on one, then install to the other. Everything went well. After installation is finished, and I restart, GRUB loads, and I select FreeNAS 9.10, but then the screen goes black, and if I leave it on for hours, I don't get the loaded screen with the IP address of the server and other things.
Could this be a USB issue? Perhaps I need to get another kind of USB? I've got the Kingston Data traveler 16gb.
Motherboard: Gigabyte x150m-pro-ecc
CPU: Intel Xeon E3-1230v5 1151
Ram: 2x 8GB ECC 2133 DDR4
HD's: 4x 3TB Red WD drives (enterprise)
Not sure if other hardware is relevant, but would anyone have any ideas as to why there's only a black screen?
I'm new to FreeNAS, and have so far done according to everything I've read in ordering and setting up parts for operation. I used two USB sticks, both 16gb, to first put the ISO on one, then install to the other. Everything went well. After installation is finished, and I restart, GRUB loads, and I select FreeNAS 9.10, but then the screen goes black, and if I leave it on for hours, I don't get the loaded screen with the IP address of the server and other things.
Could this be a USB issue? Perhaps I need to get another kind of USB? I've got the Kingston Data traveler 16gb.
Motherboard: Gigabyte x150m-pro-ecc
CPU: Intel Xeon E3-1230v5 1151
Ram: 2x 8GB ECC 2133 DDR4
HD's: 4x 3TB Red WD drives (enterprise)
Not sure if other hardware is relevant, but would anyone have any ideas as to why there's only a black screen?