10gb

  1. J

    Upgrade Network to 10Gb

    I've been running FreeNAS since 2015 i think it was still FreeNAS 9 at the time over the years i have upgraded. Im currently running Freenas 11.2-U5 on a Supermicro board (A1SRi-2758F-O) with 4 intel 1Gb nics. I created a LAG with these 4 interfaces. I recently setup a 10Gb switch and I'd...
    • joogy696
    • Thread
    • 10g 10gb freenas11.2-u5 networking
    • Replies: 6
    • Forum: Networking
  2. StoreMore

    NAS Hardware Help -- 60TB

    I have been reading about FreeNAS for quite some time now and am finally ready to start building my new NAS. I previously used another off the shelf device so all data will be moved from this device once its setup, tested, burned-in. My existing 5 bay NAS is almost filled at about 8TB. I...
  3. mullinsj08

    Poor iSCSI Performance

    Hi all, I need some advice on improving the performance of my FreeNAS server. It is primarily used to provide iSCSI storage to my 2-node ESXi cluster but currently the performance is absolutely horrid. Below is the specs of my FreeNAS: - Intel Xeon E5-1620v3 - SuperMicro X10SRi-F - 128GB DDR4...
    • mullinsj08
    • Thread
    • 10gb iscsi iscsi esxi iscsi multipath
    • Replies: 2
    • Forum: Sharing
  4. N

    From Unraid to FreeNAS with a new build

    At the moment im using Unraid on my Server with this config: CPU Prozessoren: 2 x Intel Xeon E5645 SLBWZ 6C Server Prozessor 6x 2,40 GHz 12MB Cache 1366 CPU RAM: 32GB Registered ECC DDR3 RAM (8x 4GB DIMM) running a Plex Media Server with DVR and the remove advertising function...
  5. B

    Poor 10Gb performance... help!

    Hi Forums, Here is my hardware for FreeNAS: 2X Supermicro 4U Chassis ( 24Bay and external 45 Bay ) MB: Supermicro X10DRH-C/i CPU: 2X Xeon 2.4 Ghz 2460 v3 MEM: 256GB RAID: LSI 3108 MegaRAID 6.22.03.0 - FW 24.7.0.-0026 Drives: 1x: 32GB Sandisk USB 3.0 ( boot drive ) - hd0 4X: KINGSTON...
  6. KenY21

    Problem with 10G Chelsio card

    Hi, I recently bought 10G Network Kit (2x Chelsio N320E 10Gbit + 1x3m SFP+ 10GBe Cisco cable) for my FreeNAS box (Supermicro H8SCM-F). At the moment my router (MikroTik RB4011iGS+RM) has one SFP+ port so tried to connect both, so I could backup few of my computers at the same time through the...
  7. melloa

    What is holding the transfer speed?

    Folks, While waiting on my switch to get here, i run some tests and noticed the rsync transfer speed just a little bit faster over 10gb than over 1gb. Both servers are using Chelsio 10GB 2-Port PCI-e Card PCI-E 110-1088-30, connected with a Cisco SFP-H10GB-CU1M 1 Meter Twinax 10GB Cable, both...
  8. H

    NetXtreme-E 10Gb Ethernet CM57402

    Hi, Is NetXtreme-E 10Gb Ethernet BCM57402 card supported on FreeNAS? I have FreeNAS 11.1-STABLE working fine with the built-in GB Ethernet but the newly added Broadcom NetXtreme cannot be seen in ifconfig -a and indicated as "No Driver attached" in dmesg output. Can anyone help please? Thanks...
Top