strangelove
Dabbler
- Joined
- Dec 27, 2017
- Messages
- 14
I am setting up a new system using FreeNAS 11.2 Beta. I have already set up a zpool with some datasets. Also an NFS share is working. I would like to have jails for Plex (with plexpass), Syncthing and Transmission. For the setup, I basically followed a guide from the Resource section: here. I already managed to set up a jail for Transmission. When I try to create a jail for Plex, I cannot get it working. It looks like the jail is running, and I am able to ping the default router as well as Google public DNS (8.8.8.8) from inside the jail. However, the Web UI is not accessible from within my LAN at 192.168.1.14:32400/web.
Here are the exact steps taken to set up the Plex jail:
After following these steps, I was not able to ping any routes from inside the jail. Adding the following two tunables resolved this issue:
System > Tunables
Variable:
Variable:
However, I am still not able to access the Web UI from my LAN.
Here are the exact steps taken to set up the Plex jail:
Code:
echo '{"pkgs":["multimedia/plexmediaserver-plexpass","security/ca_root_nss"]}' > /tmp/pkgs.json iocage create -r 11.1-RELEASE -p /tmp/pkgs.json -n plex ip4_addr="vnet0|192.168.1.4/24" defaultrouter=192.168.1.1 vnet=on boot=on allow_raw_sockets=1 iocage exec plex sysrc plexmediaserver_plexpass_enable=YES iocage exec plex service plexmediaserver_plexpass start iocage fstab -a plex "/mnt/tank/media/movies /media/movies nullfs ro 0 0"
After following these steps, I was not able to ping any routes from inside the jail. Adding the following two tunables resolved this issue:
System > Tunables
Variable:
cloned_interfaces
, Value: bridge0
, Type: rc.conf
Variable:
ifconfig_bridge0
, Value: addm igb0 up
, Type: rc.conf
However, I am still not able to access the Web UI from my LAN.
Last edited: