Wake on LAN - WOL - How to enable for X540-T2 DualPort 10G Ethernet - Scale

[flashdrive]

When the host / system is shut down, than there is no LED active / no blinking on the Intel NIC

WOL with onboard LAN does work.

How do I get WoL working for the X540-T2 DualPort 10G Ethernet?
Dell T20

output ethtool enp1s0f0

Settings for enp1s0f0:
Supported ports: [ TP ]
Supported link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Supported pause frame use: Symmetric
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised pause frame use: Symmetric
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: 10000Mb/s
Duplex: Full
Auto-negotiation: on
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
MDI-X: Unknown
Supports Wake-on: d
Wake-on: d
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes

---

d = disabled

I found something along this:

Wake-on-LAN - ArchWiki

wiki.archlinux.org

However I get an error message for:

ethtool -s enp1s0f0 wol g
netlink error: cannot enable unsupported WoL mode (offset 40)
netlink error: Invalid argument

 

[Redcoat]

How do I get WoL working for the X540-T2 DualPort 10G Ethernet?

This page https://www.intel.com/content/www/us/en/support/articles/000005793/ethernet-products.html

"Remote Wake up Basics for Intel® Ethernet Products"

states " 10-Gigabit Ethernet adapters

Wake-on-LAN isn't supported on Intel® Ethernet 10-gigabit adapters."

 

[flashdrive]

@Redcoat
Thank you for the doc.


Is there really no way to active WOL ?