Brand new to freeNAS. I was testing setup and then I wanted to delete the volume I created and start from scratch. I forgot to select "mark drive as new" when doing that and now I can't see the disks anywhere in FreeNAS. How can I get them to show again?
I was told to look at /var/run/dmesg.boot so I could try
when I look at dmesg.boot I can only see
I've also tried:
This gives me:
also tried the following:
All this still shows the same two devices
Booting with Gparted live gives similar results.
I was told to look at /var/run/dmesg.boot so I could try
gpart destroy -F /dev/daN dd if=/dev/zero of=/dev/daN count=10
when I look at dmesg.boot I can only see
ada0
and ada1
. My other 5 disks are still missing. Those are the drives I am trying to bring back up and use the gpart destroy
on..... I can't do that without device numbers. Is there something I am missing here?I've also tried:
egrep 'ad[0-9]|cd[0-9]' /var/run/dmesg.boot
This gives me:
Code:
[root@freenas ~]# egrep 'ad[0-9]|cd[0-9]' /var/run/dmesg.boot
orm0: <ISA Option ROMs> at iomem 0xc0000-0xc7fff,0xc8000-0xc8fff,0xc9000-0xc9fff
,0xcd000-0xcd7ff on isa0
[root@freenas ~]# egrep 'da[0-9]|cd[0-9]' /var/run/dmesg.boot
ehci0: <Intel 82801JI (ICH10) USB 2.0 controller USB-B> mem 0xfbeda000-0xfbeda3f
f irq 18 at device 26.7 numa-domain 0 on pci0
orm0: <ISA Option ROMs> at iomem 0xc0000-0xc7fff,0xc8000-0xc8fff,0xc9000-0xc9fff
,0xcd000-0xcd7ff on isa0
ada0 at ahcich4 bus 0 scbus5 target 0 lun 0
ada0: <SanDisk SDSSDA240G Z33130RL> ACS-2 ATA SATA 3.x device
ada0: Serial Number 172009449003
ada0: 300.000MB/s transfers (SATA 2.x, UDMA6, PIO 512bytes)
ada0: Command Queueing enabled
ada0: 228936MB (468862128 512 byte sectors)
ada1 at ahcich5 bus 0 scbus6 target 0 lun 0
ada1: <ACSC2M064S25 1.095.06> ACS-2 ATA SATA 3.x device
ada1: Serial Number 986042081062
ada1: 300.000MB/s transfers (SATA 2.x, UDMA5, PIO 512bytes)
ada1: Command Queueing enabled
ada1: 61057MB (125045424 512 byte sectors)
also tried the following:
# camcontrol devlist
# gpart show
# sh -c '. /usr/share/bsdconfig/device.subr;f_device_menu "" "" "" DISK'
All this still shows the same two devices
ada0
& ada1
Booting with Gparted live gives similar results.