Hello everyone,
I have a syncthing in Jail (default) that i can access normally. I have already made a mount point lookin to the real data on the storage pool in mnt/MirrorPool/Data.
I let it scan and :
Folder ID folderid1
Folder Path /mnt/Data
Global State 407,992 30,025 ~1.69 TiB
Local State 407,992 30,025 ~1.69 TiB
Folder Type Send Only
Rescans 5m Enabled
Shared With
Last Scan 2021-09-12 12:02:26
Send only because this is my primary SMB, my target is to sync to synology.
I'm still struggling with this task, since all kinds of problems occur.
My main question is if there are any permissions needed for syncthing jail to function properly? I didn't see anything in the procedure.
I had the watch filesystem error, i have disable this option. The 2 sides wasn’t able to sync, i found in an old post to let the folders complete the first scan, and then execute the share. I did, after 8 hours make the share, after 12 hours the status was syncing 0% with speed 0,12kb/s. I have check device id’s to be correct and also folder id’s to be the same.
any comments appreciated.
I have a syncthing in Jail (default) that i can access normally. I have already made a mount point lookin to the real data on the storage pool in mnt/MirrorPool/Data.
I let it scan and :
Folder ID folderid1
Folder Path /mnt/Data
Global State 407,992 30,025 ~1.69 TiB
Local State 407,992 30,025 ~1.69 TiB
Folder Type Send Only
Rescans 5m Enabled
Shared With
Last Scan 2021-09-12 12:02:26
Send only because this is my primary SMB, my target is to sync to synology.
I'm still struggling with this task, since all kinds of problems occur.
My main question is if there are any permissions needed for syncthing jail to function properly? I didn't see anything in the procedure.
I had the watch filesystem error, i have disable this option. The 2 sides wasn’t able to sync, i found in an old post to let the folders complete the first scan, and then execute the share. I did, after 8 hours make the share, after 12 hours the status was syncing 0% with speed 0,12kb/s. I have check device id’s to be correct and also folder id’s to be the same.
any comments appreciated.
