Hello,
First post here.
I built a new FreeNAS box yesterday and having issues with booting up.
My Specs:
* CPU: Intel G3930 Kaby Lake Processor
* RAM: 8GB Corsair LPX
* Motherboard: Gigabyte GA-H270N-WiFi
* 3x3TiB WD Red
* 1x60GB Intel SSD
* Patriot USB 3.0 installation drive
FreeNAS version: 9.10
While the installation goes well, when booting from USB drive, the boot sequence hangs at:
`Loading kernel modules…`
### Other Info
Interestingly, the FreeNAS version 10, beta 2 boots up just fine. However there are other issues with it, such as creation of a dataset (permissions error).
My suspicion is that the H270 chipset isn't supported yet... but since I can boot version 10 just fine, I am not sure.
I would like to use the FreeNAS 9. Any help would be appreciated.
Thank you.
First post here.
I built a new FreeNAS box yesterday and having issues with booting up.
My Specs:
* CPU: Intel G3930 Kaby Lake Processor
* RAM: 8GB Corsair LPX
* Motherboard: Gigabyte GA-H270N-WiFi
* 3x3TiB WD Red
* 1x60GB Intel SSD
* Patriot USB 3.0 installation drive
FreeNAS version: 9.10
While the installation goes well, when booting from USB drive, the boot sequence hangs at:
`Loading kernel modules…`
### Other Info
Interestingly, the FreeNAS version 10, beta 2 boots up just fine. However there are other issues with it, such as creation of a dataset (permissions error).
My suspicion is that the H270 chipset isn't supported yet... but since I can boot version 10 just fine, I am not sure.
I would like to use the FreeNAS 9. Any help would be appreciated.
Thank you.
Last edited: