Power Outage Freenas would not boot. Stuck at db>

[jason2g]

I had a brief power outage this morning and my Freenas server did not come back up. The console should the db> output and would not do anything else. I did a fresh install of the Freenas 9.2.0 x86 and got it to boot and was able to successfully import one of my zfs pools labeled Movies. My other pool labeled Data will not import. It shows up as available when I try to do the auto import volume in the gui but errors out and just puts a bunch of text across the console before it reboots. It is a Dell XPS 400 with 4GB of RAM two 500GB drives and 2 3TB drives. When I run zpool status the Movie pool shows up as it is supposed too but not the Data. I have run zpool import and this is the output. If I need to recreate the pool that is fine but how do I retrieve the data off of here. It is a mirrored zfs pool. Thanks for your help in advance.

[root@freenas ~]# zpool import
pool: Data
id: 3952745769883719081
state: ONLINE
action: The pool can be imported using its name or numeric identifier.
config:

Data ONLINE
mirror-0 ONLINE
gptid/94edaf2a-89b6-11e3-a916-0013721ca27a ONLINE
gptid/956a70cd-89b6-11e3-a916-0013721ca27a ONLINE

 

[dlavigne]

Post the output of "zpool status" within code tags.

 

[HoneyBadger]

Check your hardware, we just had another user lose a pool due to non-ECC RAM, and not only are you using non-ECC RAM but you're only using 4GB of it as opposed to the 8GB minimum recommendation.

Run memtest from a bootable disk and let it check for errors for at least 8 hours. If you don't get any then try an import in recovery mode following these guidelines. If that fails, it's dead, Jim.