Only one Disc detected in Qnap TR-004U USB Enclosure

[menzbua]

Hi,

i have a problem with my fresh TrueNAS Setup. I have an QNAP TR-004U USB Enclosure with two 6TB WD Red Harddrives. The TrueNAS is connected via USB to an Intel NUC.
In dmesg and in camcontrol devlist i see both drives:

root@truenas[~]# camcontrol devlist
<KINGSTON SMS200S330G 507KC4> at scbus0 target 0 lun 0 (pass0,ada0)
<AHCI SGPIO Enclosure 2.00 0001> at scbus1 target 0 lun 0 (pass1,ses0)
<QNAP TR-004U DISK00 6307> at scbus3 target 0 lun 0 (da0,pass2)
<QNAP TR-004U DISK01 6307> at scbus3 target 0 lun 1 (da1,pass3)
root@truenas[~]#

But in the TrueNAS WebUI i only see the drive da1. On the USB enclosure the Jumpers are set to individual drives.
Is this a general problem with the QNAP TR-004U and TrueNAS or is there some config i'm missing?

Thanks a lot
Regards
Manuel

 

[Alecmascot]

NVMe drives in USB case show same Serial Number

I have attached to NVMe drives in USB cases to my HPE Microserver Gen10+. In the GUI in can only see one. The serial number for both drives shows as "0123456789ABCDEF" which is probably the cause for this. Is there a way to to make the GUI read the correct serial number? Or change the serial...

www.truenas.com

 

[menzbua]

Thanks for the link.

I've created the pool via the command line. Hopefully this ist not a problem when i upgrade to the fixed version?

Regards
Manuel